Well aware of the Windows tcp stack "features", and autotuning was already set to normal.Ĭonnection is 1000/500, in Auckland. And booting into Linux and testing via that. It may be worth mentioning what router you're using too. Since you're using Windows it is highly likely you're running into the "classic" rubbish state of Windows TCP tuning. I’m not that deep into Linux to know such tweaks.Nope, I am getting ~900Mbit to the US on 2degrees currently so this is 100% just you. I think, this is really the HW limit, sadly. I get around 5-600Mbit/s (actual bit less, because lot of people are at home and it’s a shared FAN node from Swisscom).Īll 4 cores go up. Some on, some with a 30GB File diretcly from my ISP (alternative to iperf). In the meantime I managed to do some speedtests. Sudo echo “f” > /sys/class/net/eth2/queues/rx-0/rps_cpus Sudo echo “f” > /sys/class/net/eth1/queues/rx-1/rps_cpus Sudo echo “f” > /sys/class/net/eth0/queues/rx-1/rps_cpus
Sudo echo “f” > /sys/class/net/eth1/queues/rx-0/rps_cpus Sudo echo “f” > /sys/class/net/eth0/queues/rx-0/rps_cpus The following statement is in my /config/scripts/vyos-postconfig-bootup.script: I hope you don’t mind when I applied this statement also to the rx-1 queue of the interfaces. So I can’t show you a screen of top and my configuration. Sadly I’m not allowed to add attachements for the moment. RCU: 965068 1985195 850226 sudo ethtool -g eth0ĭo you see any further potential for optimization or is the hardware on its limits? Rx-0 rx-1 tx-0 ls /sys/class/net/eth2/queues/ Rx-0 rx-1 tx-0 ls /sys/class/net/eth1/queues/ ETH0 and ETH1 have 4 HW queues, ETH2 has 2 of ls /sys/class/net/eth0/queues/ ETH0 is the WAN interface for the PPPoE connection, ETH1+2 are configured as a Bond to my Cisco SG300 Switch. The APU Board has three ethernet ports provided by an Intel I211AT. This is the result after I applied the optimisation mentioned in this thread. The firewall has only the default rules as mentioned in the documentation (NAT Masquerade and allow in if there is an outgoing connection first).The line itself is a 1Gbit/s FTTH Connection. Local, from VyOS to my PC i have ~950Mbit/s with iperf3 and 4 parallel sessions. However, since i switched to VyOS I can’t establish an iperf3 session to my ISP. I receive a peak of around 690MBit/s in Downstream and around 500MBit/s in the upstream on. Sadly, the throughput isn’t much higher than on OpnSense (the main reason I switched).
I chose VyOS to replace OpnSense on my APU3C4 Board (AMD GX-412TC 1GHz, 4GB RAM, 60G mSATA). Last week I installed VyOS for the first time.
0 kommentar(er)
